Whats next for you?

In-N-Out

previously Cowlhead
Whats next for you guys on the building board? I have a couple of projects coming up? What are your plans for this build?

Lanier 1/3 Extra 300 - Typical built DA or 3W motor Don't know complete details yet. I am going to use the direct drive.


Sopwith Camel Balsa Usa - Scale Build

Kadet Senior - Aerboatic with barndoor Alierons. Should be fun to mess around with

I would like to have another 35%r on the table but well see
 

Rabbit Ron

Circus Staff
The following is a production list for Rabbit Ron Entertainment LLC.

the list may get smaller or larger at a moments notice depending funds

the list is in no particular order and is not intended to upset or per sway the general public


electric 30 Katana

40% Votec

various foam

40% Votec

Pal mini yak (Hacker 20/20 size)

40% Votec

Addiction 3D

40% Votec
 

In-N-Out

previously Cowlhead
The following is a production list for Rabbit Ron Entertainment LLC.

the list may get smaller or larger at a moments notice depending funds

the list is in no particular order and is not intended to upset or per sway the general public


electric 30 Katana

40% Votec

various foam

40% Votec

Pal mini yak (Hacker 20/20 size)

40% Votec

Addiction 3D

40% Votec

Votec Baby get'r done
 

Mithrandir

Circus Staff
Lifetime Supporter
I should be getting my VOTEC in about 5 days... I need to order some Monocte!!! :eek:
I am thinking TFC Scheme
 

Showtime

Circus Staff
My list is real short.
39% krill
And if i am lucky a new trailer. Cause some dumb ass crashed mine.
 

Gmoney

Circus Staff
Why Cowlhead? Why?

Ok
1. Finish Airfoilz
2. Finish 42% SD 260
3. Finish 50% Hemple Edge
4. Finish Synergy N9
5. 1/3 scale Mong- complete rebuild and retro fit
6. finish .30 pitts bipe
7. double deck trailer
8. 1/3 scale Decathalon-Hostetler plans
9. 50 size civilian MD- Electric

That should get me through the year. That does not count what I will build or help build for others.. If I finish my list I will have zero half done personal projects.. My problem is one project always presents another project.. I have my eyes open all the time for that killer challenge..

G
 

In-N-Out

previously Cowlhead
Why Cowlhead? Why?

Ok
1. Finish Airfoilz
2. Finish 42% SD 260
3. Finish 50% Hemple Edge
4. Finish Synergy N9
5. 1/3 scale Mong- complete rebuild and retro fit
6. finish .30 pitts bipe
7. double deck trailer
8. 1/3 scale Decathalon-Hostetler plans
9. 50 size civilian MD- Electric

That should get me through the year. That does not count what I will build or help build for others.. If I finish my list I will have zero half done personal projects.. My problem is one project always presents another project.. I have my eyes open all the time for that killer challenge..

G
Because I'm itching for a project. I know I have the Sopwith, and the Kadet but those are kits, and wanted to see what other people have on the table.
 

mxwrench

Well-Known Member
My list is short but complicated...

1.Finish designing and prototype 50-200cc airlplane engine dyno.
2.110" Extreme flight YAK w/da85
3.Design expansion chamber exhaust for 110" yak w/da85
4.Test run pipe and engine on dyno
5.Make changes to pipe
6.Repeat steps 4-6 until results surpass DA150 power output!!

1a. Take racebike to trackday
1b. Repeat as needed

BK
 

ottrod

Well-Known Member
1. Finish and fly W/H 28% Edge 540 Red Bull Scheme (real close!!!)

2. Backup FancyFoam Edge

3. The new Aeroworks Baby Extra

4. Possibly convert my Aeroworks 90-1.20 Yak from glow to gas.

5. Hopefully do not re-kit anything in the process!
 

Mithrandir

Circus Staff
Lifetime Supporter
Well... my real "Next Project" was a Charger RC CR-1... but I just finished that at my parents house in Dayton... Maybe when I am done with it I will give it to some kid at the local flying field!?!?!?
 

Stubbs

WTF
finish up team build of AJ p-38
KMP P-47 (tear down, glass scale paint job)
start Meister-scale 102" p-47
Figure out my 35% situation (horizon replace, or buy something)
Something for my 50cc sitting here
yellow p-47 or similar
get the funds for the above projects
 

zman

Well-Known Member
Mine is pretty easy.
1) 39% aeroworks 300l kit
2) 35% sd yak 54
3) 33% sd yak 54
Fuse is framed up on extra, wings are next.
 

GmanBIll

Well-Known Member
75cc extra 260
Fokker D7 quarter scale
finish my ZN Line (as soon as I have a design for the AMA team)
build a slick 540
build a couple more 50cc planes (put one in wed.)
all that between customers planes and the AMA Show team stuff, so not a lot.
 

Barry Built

Lifetime Supporter
Finish QQ 38% YAK..

Move into new house

Have shop and pool built

Have circus aviators over (after flying at Rabbit) for swim and BBQ)

Possible comp arf in near future..
 

TManiaci

Engineer
Lifetime Supporter
My big challenge is getting out to a field somewhere and flying! Other than sim time, I have not been out to fly in 4 months. This is KILLING me!
 
Top